Windows 10 Test Mode Watermark on Desktop: Removing the Text in the Corner of Your Screen
You notice text in the bottom-right corner of the desktop reading “Test Mode,” followed by your Windows edition and build number. It stays above every window and does not go away after a restart. When the Windows 10 Test Mode watermark on desktop appears, Windows has been switched into a mode that allows PAGODA127 SLOT unsigned drivers to load.
Test Mode, also called test signing, is meant for developers testing their own drivers. Normally Windows refuses drivers without a valid digital signature. Some older hardware tools, modding utilities, and unofficial drivers turn on Test Mode so their drivers can load.
That makes the PC less secure, because any unsigned driver, including a malicious one, can run. The watermark is a reminder of that.
Turning test signing off removes the watermark, but anything that depended on it may stop working.
What Usually Triggers It
Test Mode turns on for these reasons:
- A program or driver installer enabled test signing.
- A user ran bcdedit /set testsigning on while following a guide.
- Driver signature enforcement tweaks were applied.
- Malware enabled it to load an unsigned driver.
If you do not recognise any tool that needed unsigned drivers, treat the watermark as a reason to scan the PC.
The watermark is different from the “Activate Windows” watermark. Test Mode always names the edition and build number, while activation reminders do not.
First Steps to Try
Think about what needs it.
- List recently installed hardware tools, mod managers, or unusual drivers.
- Check the device or tool’s documentation to see whether it requires Test Mode.
- Look for a signed, official driver version that does not need Test Mode.
- Run a Full scan with Microsoft Defender.
- Create a restore point before changing boot settings.
If the Problem Continues
Turn off test signing.
- Right-click Start and open Command Prompt (Admin) or Windows PowerShell (Admin).
- Type bcdedit /set testsigning off and press Enter.
- If you see an error about Secure Boot policy, disable the tool that enabled it or check BIOS settings, then try again.
- Restart the PC.
- Check that the watermark is gone and your devices still work.
If a device stops working afterwards, find an officially signed driver from the manufacturer instead of turning Test Mode back on.
Protect Your Data First
Running permanently in Test Mode weakens a core security protection. Keep Secure Boot enabled where possible, and avoid tools that require unsigned drivers unless you fully trust them.
The Bottom Line
The Test Mode watermark means Windows allows unsigned drivers. Find the tool that needed it, replace it with a signed driver, and run bcdedit /set testsigning off to remove the watermark and restore protection.